Select Language  * Japanese  * Chinese Automotive electronics parts die We use materials - Iron, Copper, and aluminum – thickness of which are from 0.8mm to 4.0mm, and total length of dies are up to 2500mm. Also range OSK can deal with is drawing, production, trial run and shipment. Core die for generators, cooling fan die, heat sink die for rectifiers Rotor core die for starter motor, metal fixture brush holding die Die for wiring harness, various terminal dies Various metal fixture connector dies for condenser and evaporator of air conditioner Various fuel and control system parts dies   Die for alternator parts Transfer die Terminal die for wiring harness HVAC equipment die Name Radiator Parts Material Aluminum Thickness 1.2mm Sales point integrating two exisiting parts Comments Inside wall surface roughness is important Name Heat exchange parts Material Aluminum Thickness 1.0mm Sales point integrating three exisiting parts Comments Inside wall surface roughness is important Name Radiator parts Material Aluminum Thickness 1.2mm Sales point   Comments Very tighten torelance is required Dies for various motors (case, connector, brush, commutator) Name Brush for motor Material Phosphor bronze Thickness 0.1mm Sales point   Comments   Name Brush (motor contactor) Material Phosphor bronze Thickness 0.07mm Sales point R cutting tip Comments 800spm